Category Archives: AMSAT

Low cost frequency standard

I have been looking for a low cost frequency standard for a while to replace one I once had about 10 years ago. The only way to do it then was to build a GPS locked oscillator. I chose the extreme overkill route and locked a doubtful rubidium standard to GPS. It worked for a while and then the rubidium kit stopped working.

The next solution was to lock a temperature-controlled 10Mhz crystal oscillator. It worked well enough as along as it was left on all the time. Recently I have been looking for a cheaper and less complex way of providing a 10Mhz standard signal for test equipment and radios.

Things have moved on and the GPS modules that used to be relatively cheaply available on ebay are no longer there. Ditto oven-controlled oscillators. Then I found the ideal solution on the QRP Labs web site; a “ProgRock – triple GPS-disciplined programmable crystal” which is basically a Si5351A chip programmed for a single frequency. It can be GPS locked via a 1PPs signal from a GPS receiver, the “QLG1 GPS Receiver kit.” An order was placed.

The kits arrived, and I spent a few hours yesterday building them. As usual with QRP Labs kits they all worked first time. The first check was my £17 ebay counter, a Racal-Dana 9918. It was 5.2Hz low at 10Mhz! I could try adjusting the internal 10Mhz oscillator but it might take a while to get it to read 10,000,000!

The better option is to complete the project by building a small distribution amplifier which will give 3, 10Mhz sine wave outputs from the ProgRock and use one of them as an external timebase for the counter.

The PrgRock with scope probe attached

GPS board with patch antenna.

The kits, parts for the distribution amp and a case will cost around £35 in total. That is probably about one tenth the cost of the previous project!

Is this all overkill? Well yes and no. Modern transceivers are accurate but when you build your own you never know. Also, the move to VHF, UHF and microwave for satellites means I want to be sure that the frequencies are correct. This crucial when multiplying up free running crystal oscillators as any error will also be multiplied.

The usual disclaimer, I have no connection with QRP Labs other than being a satisfied customer. This review/article was not solicited by them and they had no knowledge I was doing it.


Slow scan TV from the ISS

At the third attempt I managed to copy an SSTV image from the ISS. It is noisy as it was orbit 1924 which showed a minimum distance of 1038km and maximum elevation of 19.15 degrees.

I used the dual band antenna I made last week with a Baofeng GT-3 and a Zoom H5 audio recorder. It all worked well enough but a bit more gain at 2m would have helped. I am thinking of making crossed yagis for both 2m and 70cms. As the wind chill was somewhere around -3C today the new antennas will be motor driven!